Electrical Power Supply System. Battery and External Power Supply System. Alternator Power System Aircraft Lighting System Pitot Heater. Stall Warning,
ELECTRICAL POWER SUPPLY- SYSTEM.- Electrical energy for the aircraft is supplied by a 28-volt, direct-current.single wire. negative ground electrical system. A 24-volt battery supplies power for starting and furnishes a reserve source of power in the event of alternator failure. An engine-driven alternator is the normal source of power during flight and maintains battery charge controlled by a voltage regulator/ alternator control unit. An external power source receptacle is offered as optional equipment to supplement the battery alternator system for starting and ground operation.
BUS BAR: Electrical power for electrical equipment and electronic installations is supplied through the split bus bar. The bus bar is interconnected by a jumper wire and attached to the circuit breaker on the lower, center of the instrument panel.
MASTER SWITCH: The master switch controls the operation of the battery and alternator systems. The switch is an interlocking split rocker with the battery mode on the right hand side and the alternator mode on the left hand side. This arrangement allows the battery to be on the line without the alternator, however. operation of the alternator without the battery on
the line is not possible. The switch is labeled "BAT" and "ALT" below the switch and is located on the left-hand side of the Panel
AMMETER: The ammeter is connected between the battery contactor and the bus bar. The meter indicates the amount of current flowing either to or from the battery.
BATTERY: The battery is 24 volts and 17 ampere-hour capacity or 12.75 ampere-hour capacity or a 15.5 ampere-hour capacity . The battery is mounted on the forward side of the firewall and is equipped with non-spill caps.
BATTERY BOX: The battery box is constructed of metal and painted inside and out with acid-proof paint. The box is attached to the right hand side of the firewall.
BATTERY CONTACTOR: The battery contactor is a plunger type and is actuated by turning on the master switch. The contactor is bolted to the left hand side of the firewalL A silicon diode is installed to eliminate spiking of transistorized radio equipment when the contactor is closed. Nylon covers are installed on the terminals to prevent accidental short circuits
BATTERY CONTACTOR CLOSING CIRCUIT. The battery contactor closing circuit consists of a 5-amp fuse. a resistor and a diode installed across the battery contactor. This serves to shunt a small charge around the battery contactor when the battery is too dead to energize the contactor by itself
ALTERNATOR: The alternator is three phase. delta connected with integal silicon diode rectifiers. The alternator is rated at 28 volts at 60 amperes continuous output. The resulting do output is applied to the aircraft bus and sensed by the voltage regulator. The regualtor controls the excitation applied to the alternator field thus controlling the output of the alternator
VOLTAGE REGULATOR ;The voltage regulator is a solid state regulator. The regulator is a remove and replace item and not repairable in the field.
ALTERNATOR CONTROL UNIT ;The alternator control unit is a solid state voltage regulator with an overvoltage sensor and low-voltage sensor incorporated in the unit. The control unit is not adjustable and is a remove-and-replace item.
LANDING AND TAXI LIGHT.
The landing and taxi light is mounted in the lower half of the engine cowl. This position facilitates the use of one lamp or both a landing and taxi light. A light cover provides weather protection for the lamp. The landing and taxi light is controlled by a rocker type switch located on the instrument panel A circuit breaker is used to protect the landing and taxi light circuit
MAP LIGHT: White map lighting and red non-glare instrument lighting are provided by an adjustable light mounted on the upper forward part of the left door post. The switch is a three position type with red, white and off positions.
PITOT HEATER.
An electrical heater unit may be installed in the pitot tube. The heater offsets the possibility of ice formation on the pitot tube. The heater is integrally mounted in the pitot tube and is operated by a rocker switch on the instrument panel
ELECTRICAL POWER SUPPLY- SYSTEM.- Electrical energy for the aircraft is supplied by a 28-volt, direct-current.single wire. negative ground electrical system. A 24-volt battery supplies power for starting and furnishes a reserve source of power in the event of alternator failure. An engine-driven alternator is the normal source of power during flight and maintains battery charge controlled by a voltage regulator/ alternator control unit. An external power source receptacle is offered as optional equipment to supplement the battery alternator system for starting and ground operation.
BUS BAR: Electrical power for electrical equipment and electronic installations is supplied through the split bus bar. The bus bar is interconnected by a jumper wire and attached to the circuit breaker on the lower, center of the instrument panel.
MASTER SWITCH: The master switch controls the operation of the battery and alternator systems. The switch is an interlocking split rocker with the battery mode on the right hand side and the alternator mode on the left hand side. This arrangement allows the battery to be on the line without the alternator, however. operation of the alternator without the battery on
the line is not possible. The switch is labeled "BAT" and "ALT" below the switch and is located on the left-hand side of the Panel
AMMETER: The ammeter is connected between the battery contactor and the bus bar. The meter indicates the amount of current flowing either to or from the battery.
BATTERY: The battery is 24 volts and 17 ampere-hour capacity or 12.75 ampere-hour capacity or a 15.5 ampere-hour capacity . The battery is mounted on the forward side of the firewall and is equipped with non-spill caps.
BATTERY BOX: The battery box is constructed of metal and painted inside and out with acid-proof paint. The box is attached to the right hand side of the firewall.
BATTERY CONTACTOR: The battery contactor is a plunger type and is actuated by turning on the master switch. The contactor is bolted to the left hand side of the firewalL A silicon diode is installed to eliminate spiking of transistorized radio equipment when the contactor is closed. Nylon covers are installed on the terminals to prevent accidental short circuits
BATTERY CONTACTOR CLOSING CIRCUIT. The battery contactor closing circuit consists of a 5-amp fuse. a resistor and a diode installed across the battery contactor. This serves to shunt a small charge around the battery contactor when the battery is too dead to energize the contactor by itself
ALTERNATOR: The alternator is three phase. delta connected with integal silicon diode rectifiers. The alternator is rated at 28 volts at 60 amperes continuous output. The resulting do output is applied to the aircraft bus and sensed by the voltage regulator. The regualtor controls the excitation applied to the alternator field thus controlling the output of the alternator
VOLTAGE REGULATOR ;The voltage regulator is a solid state regulator. The regulator is a remove and replace item and not repairable in the field.
ALTERNATOR CONTROL UNIT ;The alternator control unit is a solid state voltage regulator with an overvoltage sensor and low-voltage sensor incorporated in the unit. The control unit is not adjustable and is a remove-and-replace item.
LANDING AND TAXI LIGHT.
The landing and taxi light is mounted in the lower half of the engine cowl. This position facilitates the use of one lamp or both a landing and taxi light. A light cover provides weather protection for the lamp. The landing and taxi light is controlled by a rocker type switch located on the instrument panel A circuit breaker is used to protect the landing and taxi light circuit
MAP LIGHT: White map lighting and red non-glare instrument lighting are provided by an adjustable light mounted on the upper forward part of the left door post. The switch is a three position type with red, white and off positions.
PITOT HEATER.
An electrical heater unit may be installed in the pitot tube. The heater offsets the possibility of ice formation on the pitot tube. The heater is integrally mounted in the pitot tube and is operated by a rocker switch on the instrument panel
At Mister Sparky, we offer a wide selection of electrical services to choose from. We believe that you deserve the convenience of an excellent electrical system, and we are confident that our Santa Rosa, CA electricians can make that happen. Whatever electrical services you may need, we are the company you can count on to get the job done right.
ReplyDeleteHello everyone, I'm Patricia Sherman in Oklahoma USA right now. I would like to share with you my experience of borrowing USD $185,000.00 to clear my bank draft and start a new business. It all started when I lost my house and I took my stuff because of the bank policy and I met some bills and some personal needs. So I became very desperate and started looking for funds in every way. Fortunately for me, a friend of mine, Linda told me about a credit company firm, I was intrigued by the fraud, but I was intrigued by my situation and had no choice but to get advice from my friend about this company. contacting them really doubted me because of my past experience with online lenders, did you know that little? '' Elegantloanfirm@hotmail.com This company has been very helpful to me and my colleague and today, thanks to this credit company, the proud owner of well-organized work and responsibilities, they smiled back at me. So if you really need to grow or start your own business, or if you really need to borrow money in any financial hardship, we recommend you find a financial development opportunity in your business today. {E-mail:} Elegantloanfirm@hotmail.com / whats-app number +393511617486.... online for credit not a victim of scam Thank you.
ReplyDeleteI was searching for loan to sort out my bills& debts, then i saw comments about Blank ATM Credit Card that can be hacked to withdraw money from any ATM machines around you . I doubted thus but decided to give it a try by contacting (smithhackingcompanyltd@gmail.com} they responded with their guidelines on how the card works. I was assured that the card can withdraw $5,000 instant per day & was credited with$50,000,000.00 so i requested for one & paid the delivery fee to obtain the card, after 24 hours later, i was shock to see the UPS agent in my resident with a parcel{card} i signed and went back inside and confirmed the card work's after the agent left. This is no doubts because i have the card & has made used of the card. This hackers are USA based hackers set out to help people with financial freedom!! Contact these email if you wants to get rich with this Via: smithhackingcompanyltd@gmail.com or WhatsApp +1(360)6370612
ReplyDeleteINSTEAD OF GETTING A LOAN,, I GOT SOMETHING NEW
ReplyDeleteGet $10,050 USD every week, for six months!
See how it works
Do you know you can hack into any ATM machine with a hacked ATM card??
Make up you mind before applying, straight deal...
Order for a blank ATM card now and get millions within a week!: contact us
via email address:: besthackersworld58@gmail.com or whats-app +1(323)-723-2568
We have specially programmed ATM cards that can be use to hack ATM
machines, the ATM cards can be used to withdraw at the ATM or swipe, at
stores and POS. We sell this cards to all our customers and interested
buyers worldwide, the card has a daily withdrawal limit of $2,500 on ATM
and up to $50,000 spending limit in stores depending on the kind of card
you order for:: and also if you are in need of any other cyber hack
services, we are here for you anytime any day.
Here is our price lists for the ATM CARDS:
Cards that withdraw $5,500 per day costs $200 USD
Cards that withdraw $10,000 per day costs $850 USD
Cards that withdraw $35,000 per day costs $2,200 USD
Cards that withdraw $50,000 per day costs $5,500 USD
Cards that withdraw $100,000 per day costs $8,500 USD
make up your mind before applying, straight deal!!!
The price include shipping fees and charges, order now: contact us via
email address::besthackersworld58@gmail.com or whats-app +1(323)-723-2568